印染废水处理工艺的改造

对某染织厂原印染废水处理系统存在的问题及废水水质进行了分析,在充分利用现有设施的前提下,提出了气浮／水解酸化／生物接触氧化／混凝沉淀／过滤改造工艺,增加一套气浮一体化处理设备,并将初沉池改为水解酸化池,平流沉淀池改成斜管沉淀池。改造后的废水处理系统对COD、SS和色度的去除率分别达到91．2％、90．7％、87．5％,出水水质达到了《纺织染整工业水污染物排放标准》（GB4287—92）的一级标准。     

高浓度制药废水预处理技术试验研究

以某制药厂排出的制药废水为处理对象,研究比较了混凝法、Fenton氧化法、臭氧氧化法、电解法和微电解法对废水的预处理效果。发现混凝法不能有效去除废水中的溶解性的有机物,微电解法和电解法对去除有机物有很好的效果,CODcr的去除率可达65％以上。Fenton氧化和微电解法对色度的去除效果较好,臭氧氧化和电解由于氧化还原反应可能生成一些新的物质,使得废水色度反而上升。除化学混凝法外,其他各种方法均能明显提高废水的B／C值,为后续的生化处理创造有利条件。     

Anoxic phosphorus removal in a pilot scale anaerobic-anoxic oxidation ditch process

The anaerobic-anoxic oxidation ditch (A²/O OD) process is popularly used to eliminate nutrients from domestic wastewater. In order to identify the existence of denitrifying phosphorus removing bacteria (DPB), evaluate the contribution of DPB to biological nutrient removal, and enhance the denitrifying phosphorus removal in the A²/O OD process, a pilot-scale A²/O OD plant (375 L) was conducted. At the same time batch tests using sequence batch reactors (12 L and 4 L) were operated to reveal the significance of anoxic phosphorus removal. The results indicated that: The average removal efficiency of COD, NH₄⁺, PO₄³⁻, and TN were 88.2%, 92.6%, 87.8%, and 73.1%, respectively, when the steady state of the pilotscale A²/O OD plant was reached during 31–73 d, demonstrating a good denitrifying phosphorus removal performance. Phosphorus uptake took place in the anoxic zone by poly-phosphorus accumulating organisms NO₂⁻ could be used as electron receptors in denitrifying phosphorus removal, and the phosphorus uptake rate with NO₂⁻ as the electron receptor was higher than that with NO₃⁻ when the initial concentration of either NO₂⁻ or NO₃⁻ was 40 mg/L.     

活性炭孔结构和表面化学性质对吸附硝基苯的影响

通过对活性炭HNO3氧化及随后的N2:气氛中热处理,研究了活性炭性质对其吸附硝基苯性能的影响.以低温液氮(N2/77K)吸附测定活性炭的比表面积和孔容、孔径分布,以SEM观测活性炭表面形貌,以Boehm滴定、FTIR、零电荷点pHpzc测定及元素分析定量表征活性炭表面含氧官能团变化.结果表明, HNO3氧化可以显著改变活性炭表面化学性质,增加活性炭表面酸性含氧官能团数量,对活性炭孔隙结构影响不大.随后N2:气氛中热处理可以造成活性炭表面酸性含氧官能团分解,外表面积增大,微孔烧蚀为中孔.硝基苯在活性炭上的吸附基本符合Langmuir方程,改性后活性炭对硝基苯的吸附容量明显改变, ACNO-T、ACraw、ACNO吸附容量分别为1011.31、483.09、321.54 mg·g-1.较大的外表面积、适宜数量的中孔以及较少的酸性含氧官能团是ACNO-T对硝基苯表现出较高吸附容量的主要原因.     

Co(C3H6NS2)3·C6H12N2S3单晶的制备及催化性能的研究

采用常温饱和溶液蒸发法,一硫化四甲基秋兰姆与钴(Ⅱ)发生原位反应得到一种新型非均相Fenton催化剂单晶Co(C₃H₆NS₂)₃·C₆H₁₂N₂S₃;通过单晶X衍射、红外光谱和C、N和H元素分析对该单晶结构进行了表征;该单晶的空间群为P-1,在不对称单元中有1个Co(Ⅲ)中心,3个新配体C₃H₇NS₂和1个TMTM;Co(Ⅲ)呈现出稍微偏斜的八面体的配位几何构型.利用该单晶催化氧化降解了直接蓝6和直接绿28;结果显示,在酸性和碱性条件下,染料的降解率和矿化率都较高,这是因为活性中心Co(Ⅲ)提高了H₂O₂的效率.当投加量在1 200～1 600　mg·L^-1之间时,处理90　min后,直接蓝6和直接绿28的降解效率可分别达到94.39%和94.78%.相比之下,不加该单晶光催化剂,其它条件完全相同时,处理90　min后2种染料的降解率均不到45%,降解缓慢.使用后的单晶,通过过滤,可反复使用,有利于降低处理成本.此外还研究了催化反应的动力学,反应遵从Langmuir-Hinshelwood动力学模型;2种染料降解反应速率常数k分别为3.03×10²和6.25×10²　mg·(L·min)^-1,吸附常数K分别为1.52×10^-4和7.23×10^-5　L·mg^-1.     

Influence of environmental temperature and relative humidity on photocatalytic oxidation of toluene on activated carbon fibers coated TiO2

TiO₂ supported on active carbon fiber (TiO₂/ACF), an absorbable photocatalyst, is a new kind of material applied in air purification. In this paper, the influence of environmental temperature (T) and relative humidity (RH) on the gas-solid adsorption of toluene and the photocatalytic oxidation (PCO) efficiency of adsorbed toluene on TiO₂/ACF were studied, and then, the purification capability of TiO₂/ACF was estimated. PCO results showed that although the PCO efficiency increased under high RH and T levels, the amount of adsorption of toluene decreased. Moreover, quantitative analysis results of intermediates indicated that more environmental risk emerged when PCO of toluene was carried out at higher environmental T and RH levels because more toxic intermediates would be accumulated on the TiO₂/ACF. So, it is significant to control the environmental T and RH conditions in the application of the PCO technique. T = 25°C and RH530% is the optimal condition for purifying toluene in our experimental system. __________ Translated from Urban Environment & Urban Ecology, 2007, 20(5): 10–13 [译自: 城市环境与城市生态]     

Sludge reduction during brewery wastewater treatment by hydrolyzation-food chain reactor system

During brewery wastewater treatment by a hydrolyzation-food chain reactor (FCR) system, sludge was recycled to the anaerobic segment. With the function of hydrolyzation acidification in the anaerobic segment and the processes of aerobic oxidation and antagonism, predation, interaction and symbiosis among microbes in multilevel oxidation segment, residual sludge could be reduced effectively. The 6-month dynamic experiments show that the average chemical oxygen demand (COD) removal ratio was 92.6% and average sludge production of the aerobic segment was 8.14%, with the COD of the influent at 960–1720 mg/L and hydraulic retention time (HRT) of 12 h. Since the produced sludge could be recycled and hydrolyzed in the anaerobic segment, no excess sludge was produced during the steady running for this system.     

催化剂Ru/ZrO2-CeO2催化湿式氧化苯酚

催化剂Ru/ZrO₂-CeO₂催化湿式氧化苯酚的过程表明,Ru/ZrO₂-CeO₂可以显著提高COD和苯酚去除效果,当反应温度为170℃,压力为3 MPa,反应120 min后,COD和苯酚的去除率分别达到了99％和100％.试验还考察了不同反应条件对苯酚溶液COD去除的影响,并获得了最优的反应条件：温度为170℃,压力为3 MPa,催化剂的投加量为5　g/Ｌ,搅拌速度为500 r/min.通过对中间产物的分析,本研究提出了催化湿式氧化苯酚的简单路径图,认为苯酚首先被氧化成小分子有机酸,接着小分子有机酸被氧化成二氧化碳和水.前一个过程是快速反应,后一个过程中的乙酸氧化是慢速过程,需要在高温下才能完成.乙酸的氧化主要是自由基攻击α碳上的C—H键,先生成甲酸,并最终生成二氧化碳和水.     

FCR多级接触氧化系统处理乳品工业废水的研究

为提高乳品工业废水生物处理的去污脱氮能力,以新型螺旋状纤维填料作为载体,采用多级氧化槽内不同种类微生物形成的食物链系统（food chain reactor）,详细考察了不同水力停留时间COD、TN、NH^＋₄-N、TP等的去除率及其去除机理,并对污泥减量化效果进行了初步探讨.结果表明,当进水COD为842～1 843 　mg/L、TN为36.3～92.2 　mg/L、NH^＋₄-N为30.1～52.1 　mg/L,HRT=6　h时,系统COD的平均去除率达到93.3%;TN和NH⁺₄-N的去除效果显著,其平均去除率分别达到73.3%和80.7%,出水COD、TN、NH⁺₄-N平均值分别为79.4　mg/L、9.6 　mg/L、6.1　mg/L,均低于《污水综合排放标准》（GB 8978-2002）的一级标准.该系统不仅具有较高的去污脱氮效果,而且产生的剩余污泥量极少,其污泥产率的平均值为7.7%.该系统运行费用低,操作管理方便,长期运行稳定,可应用于城市污水、中高浓度有机废水（如餐厅污水、食品工业废水）等的处理.     

微波诱导Fenton试剂氧化降解水中对硝基氯苯

采用微波辐射诱导Fenton氧化工艺处理对硝基氯苯模拟废水。考察了H2O2用量、Fe2+用量、溶液pH、微波辐射时间、微波功率对降解效果的影响;比较了微波诱导Fenton氧化法和单纯的Fenton氧化法对对硝基氯苯的去除效果。结果表明,微波辐射不仅可以提高对硝基氯苯的去除效率,还可促进对硝基氯苯的矿质化,大大提高COD去除率,并缩短反应时间。微波诱导Fenton氧化降解对硝基氯苯的适宜工艺条件为:H2O2和Fe2+用量分别为3.0g/L和160mg/L、pH为3、微波功率为800W、微波辐射时间为10min。在此工艺条件下,对硝基氯苯和COD的去除率分别可达98.9%和90.8%。